That would waste a lot of time and consume more of your hard drive space. This will eliminate the need to set up a second server using SteamCMD.exe. Once it finishes downloading the custom map(s), it will copy them to the second location and will result in a Item State 4. If the server finds that map is not installed in the first location, it will go to an Item State 0 and download a new file from Workshop. If the map is installed to the first location above, it will automatically copy that map file to the second location below without the need to download it from the Workshop. The server will check to see if the map already installed in the first location:Ĭ:\KF2Server\Binaries\Win64\steamapps\workshop\content\232090 Remember, the workshop installs custom maps under TWO different locations in your server files. You will see this warning after adding new maps to your config and launching the server. Means the server is checking to see if the map already installed so it doesn't have to download it from the Workshop. Warning: Warning, Workshop: Attempting to check if item is installed without having downloaded it.It can also mean you entered an invalid Workshop ID in your config. Means the Workshop page for the ID you entered was set to private or taken down. Warning: Warning, Workshop: Unable to download workshop item.This warning can also occur if you launch your server twice by mistake. You can fix this by closing and re-opening Steam through your taskbar and then re-launch your server. Means the server has no connection to the Workshop and it can't check any of the Workshop ID's. Warning: Warning, Workshop: Steam does not appear to be running.A pattern was found that each map that had this state were all from the same Workshop uploader, with the exception of a few others. No noticeable problems were found from this item state. Item state is 36 - Unknown but always goes away on it's own.Will update this if I find more information. Item state is 8 - Unknown but it could mean the server is having an issue with the download or checking its status, similar to Item State 20.Restart the server if you see this and make sure your connection is stable. Item state is 20 - Likely means the custom map(s) failed to be checked for updates and/or temporarily lost connection to the Workshop.It will begin to download it and replace the original file. Item state is 12 - Means the custom map is currently installed but requires an update.Item state is 0 - Means the custom map is not currently installed and will begin to download it for the first time.Item state is 4 - Means the custom map is installed and up-to-date.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |